MC-614
QUICK START GUIDE
Ignition
Connector 1
Connector 2
17
16
15
14
12
13
10
11
9
7
6
5
8
4
3
2
1
External Regulator
Plug
Positive Battery Sense
(Required for Internal Regulator Only)
Isolated Ground Terminal
MUST be connected to system ground
Positive Output
Terminal
HOUSE BATTERY
BANK
10A
1A
D+
The wire diagram above shows a typical set-up for a
6-Series alternator to a MC-614 regulator. Connector 1
is for use with the internal regulator which connects to a
Yanmar Engine harness. Connector 2 is used with the
MC-614 or ARS-5 (as shown).
Alternators other than the 6-Series have similar, but
slightly different connections. If programming for specific
battery type, 12.5 volts on the battery are necessary.
Please refer to the Alternator Installation Guide for
specific connections.
FLIP OVER FOR MORE INFORMATION
1. Ground Input
2. Power Input
3. Ignition Input
4. Field Output
5. Alt. Temp.(-)
6. Alt. Temp.(+)
7. Bat. #1 Temp.(-)
8. Bat. #1 Temp.(+)
9. Positive Voltage Sensor
10. Data TX
11. Data RX
12. Stator In
13. Tach. Out
14. Bat. #2 Temp. (-)
15. Bat. #2 Temp. (+)
16. Aux. #1 Lamp
17. Dash Lamp
MC-614
Installation &
Operation Manual
www.balmar.net / Customer Service: +1 (360) 435-6100 x 1 / Technical S1 (360) 435-6100 x 3
SUP-0239 REVA
+
