54
Figure 1: wxPropView - Digital I/O - Pass-through of a digital signal
1.14.1.2
Working with pulse start events
The pulse start configuration list represents a
Hardware Real-Time Controller
(HRTC) as known from
USB 2.0 camera mvBlueFOX. The mvHYPERION features two HRTC's (PulseStartConfiguration0 and PulseStart
←
-
Configuration1). A HRTC generates signals at the digital outputs, which can be defined by the user.
Currently you can use the HRTC in three ways:
•
Periodical repeat of the pulse sequence
–
parameters
:
* frequency of the pulse sequence [Hz]
•
Single run through
–
parameters
:
* digital input or on-board signal, which starts the pulse sequence initially -
>
"DigitalSignal"
* falling or rising edge of the digital input -
>
"TriggerMoment"
The following sample shows, how a
SinglePulse
with 41 us width at
CC1
is defined, which
will start after a
FallingEdge
at the
Sync-In
input:
MATRIX VISION GmbH