Balluff BVS HS-Q Series, Operation Manual

Page: 122 / 296

122
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Code 128 Set Length 2
This feature specifies one of the barcode lengths for Code 128 Length Control on page 120 .
Length 2 is the maximum label length if in Variable Length: For variable length decoding, a mini-
mum and maximum length may be set. on page 231 Mode, or the second fixed length if in Fixed
Length: For fixed length decoding, two different lengths may be set. on page 231 Mode. Length
includes the barcode’s data characters only.
The length can be set from 1 to 80 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table Code 128 Length 2 Setting Examples provides examples for setting Length 2. See
page 232 for detailed instructions on setting this feature.
Code 128 Length
2 Setting
Examples
.
STEP ACTION EXAMPLES
1 Desired Setting
00 (Ignore
This Length)
07 Characters 15 Characters 80 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 128 LENGTH 2 SETTING
4
Scan Two
Characters From
Appendix 18, Use
the barcodes in
this appendix to
enter numbers as
you would select
digits/characters
from a keypad.
‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘8’ and 0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Code 128 Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CC8L2
~
DEFAULT
80 = Length 2 is 80 Characters