Balluff BTL7-A5-M Series, User Manual

Page: 40 / 146

english 14
6
Calibration procedure (continued)
6.3.2 Adjust
The detailed procedure for adjusting is
described on page 16 ff.
The factory-set null point and end point are replaced by a
new start point and end point and the associated output
values can be adjusted. The start and end values can be
adjusted as you like up to the limits.
Steps:
►
Move float to the new start position.
►
Read new start point by activating the programming
inputs.
►
Set the desired start value by activating the
programming inputs.
New null point
Before
After
New start
value
Fig. 6-4: Adjust a new start value
►
Move float to the new end position.
►
Read new end point by activating the programming
inputs.
► Set the desired end value by activating the
programming inputs.
New end point
Before
After
New end value
Fig. 6-5: Adjust a new end value
6.3.3 Reset
Restoring the BTL to its factory settings.
The detailed procedure for the reset is
described on page 18.
BTL7-A/C/E5 _ _ -M _ _ _ _ -SF-F _ _
Magnetostrictive Linear Position Sensor – Rod Style