Balluff BOS R254K-UUI-RH10-S4, Configuration Manual

Page: 200 / 214

92 english
7.3 Reset Commands
7.3.1 Description
The device supports various reset commands for resetting
the set parameters to default values. Each of these
commands is accessed by means of System Commands .
This function is defined in the IO-Link specification and is
implemented according to Version 1.1.2.
7.3.2 ISDU
Name Index Subindex Access Length Data Type Data Storage Default
System Commands 0x0002 (2) 0 W 1 byte UINT8 n/a –
Tab. 7-8: Reset Commands – ISDU
7.3.3 System Commands
Command Value Device Action
0x80 (128)
Device Reset
– Device Reset means a warm start of the device. During this process, the
microcontrollers are restarted and all initializations performed again without any change
made to the parameter values.
0x81 (129) Application Reset – This reset is performed using IO-Link specification V1.1.2.
– Resets all parameters and device settings to default values (with the exception of the
identification and tagging parameters)
– No reset of the configuration of the device variant
– Set DS-Upload request (accept the data in the memory)
– No communication stop or restart
0x82 (130) Restore Factory Settings – This reset is performed using IO-Link specification V1.1.2.
– Reset all parameters and device settings to default settings (including identification and
tagging parameters)
– Reset the configuration of the device variants to the default variant
– No DS-upload-request
– No communication stop or restart
0xA5 (165) Maintenance Reset – Resets all resettable maintenance and service life parameters for the
user so that the next maintenance cycle can begin.
Tab. 7-9: Reset Commands – System Commands
For an overview of all System Commands, see section 3.5
on page 25.
7
System Functions (continued)
BOS R254K-UUI-RH10-S4
Photoelectric Sensors