BMF 235
Sensor family
10
5
Teaching in switchpoints
5.1 Manually teaching in switchpoints S1 and S2
NOTICE
Using pointed objects to operate the button may damage it.
►
Do not press the button with a pointed object.
Only teach in switchpoints when installed.
Ferromagnetic material in the direct vicinity of the sensor can change the sensor’s behavior.
►
To teach in the switchpoints, remove the Allen key from the screw head.
Applying supply voltage
Control element without supply voltage
If the supply voltage is correct, the green LED on the control element will
light up.
Teaching in switchpoint S1
1.
Pull out the piston rod up to the 1st desired position.
2.
Press and hold the button.
⇒
The green LED begins to flash, indicating that teach-in mode is
active.
⇒
After 3 seconds, the yellow LED (switchpoint S1) will also begin to
flash.
3.
Release the button.
⇒
The sensor is now ready to teach in the first switchpoint.
4.
Press the button once more briefly.
⇒
Switchpoint S1 is now saved and the green LED is lit constantly.
⇒
If the piston remains unchanged in position 1, the yellow LED also
lights up now. This means output S1 is switched.
