Balluff BIS U-6020-053-10 RS232, Technical Description, Operating Manual

Page: 5 / 50

www.balluff.com
BIS U-602_ Processor Unit
TCP/IP / RS232
5
The processor unit BIS U-602_ is a component of the identification system BIS U. Within the
identification system, it is used to connect to a higher-level controller (PLC, PC); it may only be
used in the industrial sector.
This description applies to processor units of the following series:
– For operation within the European Community
BIS U-6020-053-10_ -…
BIS U-6027-054-10_ -…
– For operation in the USA, Canada, Mexico and Argentina
BIS U-6020-059-11_ -…
BIS U-6027-060-11_ -…
– For operation in China
BIS U-6020-059-12_ -…
BIS U-6027-060-12_ -…
– For operation in Brazil
BIS U-6020-059-13_ -…
BIS U-6027-060-13_ -…
– For operation in Japan
BIS U-6020-059-15_ -…
BIS U-6027-060-15_ -…
– For operation in Australia
BIS U-6020-059-17_ -…
BIS U-6027-060-17_ -…
Caution!
The pictogram used with the word "Caution" warns of a situation that could harm
someone's health or damage equipment. Failure to observe these warning notes may
result in injury or damage to equipment.
►
Always observe the described measures for preventing this danger.
Caution!
This UHF system consists of a processor unit and antennas according to specifica-
tions and may only be operated within the specified countries subject to all applicable
national legal regulations and standards.
►
When using the UHF system in the European Community, the provisions in ETSI
standard 302 208 apply.
►
When using the UHF system in the USA, the directives of the FCC, Part 15 B and
15 C, apply.
►
When using the UHF system in Canada, the directives of the IC, RSS-210 apply.
►
When using the UHF system in Mexico, the directives of the SCT, NOM-121-
SCT1-2009 apply.
►
When using the UHF system in Argentina, the directives of Resolución SC 729/80
and SC 784/87 apply.
►
When using the UHF system in Brazil, the directives of the ANATEL, 506/2008
and 442/2006 apply.
►
When using the UHF system in China, the directives of the RFID National Stan-
dard and GB 9254 apply.
►
When using the UHF system in Japan, the directives of "Radio Law" and ARIB
T106 apply.
►
When using the UHF system in Australia, the directives of the Radiocommunica-
tions Class License 2000 (Item 32A) apply.
2.1 Intended Use
2.2 Meaning of
Warning Notes
2.3 General Safety
Notes
2
Safety