Balluff BIS M-4008-048-0 ST4 PROFINET Series, Operating Manual, Page: 52 / 232

BIS M-4008-048-0xx-ST4
PROFINET
4
This manual describes the compact processor of the identification system
BIS M-4008 as well as its startup for immediate use..
The following conventions are used in this manual:
Enumerations are shown as a list with an en-dash.
– Entry 1,
– Entry 2.
Action instructions are indicated by a preceding triangle. The result of an action is indicated by
an arrow.
►
Action instruction 1.
⇒ Action result.
►
Action instruction 2.
Numbers:
– Decimal numbers are shown without additional indicators (e.g. 123),
– hexadecimal numbers are shown with the additional indicator
hex
(e.g. 00
hex
)
.
Parameters:
Parameters are shown in italics (e.g. CRC_ 16 ).
Directory paths:
References to paths where data is stored or to be saved are shown in small caps
(e.g.
P
roject
:\D
ata
t
yPes
\U
ser
-D
efineD
).
Control characters:
Control characters for sending are set in angle brackets (e.g. <ACK>).
ASCII code:
Characters transmitted in ASCII code are set in apostrophes (e.g. 'L').
Caution!
This symbol indicates a security notice which must be observed.
Note, tip
This symbol indicates general notes.
1.1 About this
Manual
1.2 Typographical
Conventions
Enumerations
Actions
Syntax
1.3 Symbols
1
User Instructions