Balluff BIS M-370-000-A02, Manual, Page: 50 / 198

INSTALLATION
43
2
2.6.2 Installing the BIS M-620-067-A1-04-S_ RS485
Figure 28 - RS485 Typical Layouts
See Gateway or Hub Reference Manual for further connection details.
The BIS M-620-067-A1-04-S_ Processor unit
is designed for Subnet16™ RFID applications,
where the processor unit
is connected in an RS485 network via Subnet16™-compatible
cables to the host through a Gateway or Hub.
1. Select a suitable location for the BIS M-62_ Processor unit/Antenna.
2. Mount the BIS M-37_ antenna to the BIS M-62_ Processor unit, either directly or
remotely, as described in par. 2.2.
3. Mount the processor unit and antenna to your mounting fixture using M5 (or #10)
diameter screws ( not included ) and secure them with appropriate washers and nuts.
Tighten screws to 1.7 Nm or 15 lbs per inch ± 10% .
4.
Attach a Subnet16™ compatible cable (i.e. BCC0ET0) to the M12 5-pin male Subnet16™
connector on the processor unit
. Connect the other end of this cable to your Subnet16™
network.
5.
To complete the Subnet16™ network installation, including power supply wiring, trunk
wiring, network termination, Gateway/Hub wiring, and for a complete list of compatible
accessory cables and Subnet16™ network layout examples, see the Subnet16™
Gateway or Subnet16™ Hub Reference Manuals.
After installation, the Subnet16™ network can be configured through the Subnet16™
Gateway/Hub using the
Dashboard™ Configuration Tool. See the Dashboard™ Manual for
details.
B
CC
0
E
T
0
BIS M-620-067-_ w antenna
BCC0ET0
B
CC
0
9
M
R
BIS M-620-067-_ w antenna
Gateway
to
Host
to
Configuration PC
to Power Supply
Vdc GND
BCC06ZF
BCC0ET0
BCC0ET0
BCC0ET0
B
CC
0
E
T
0
B
CC
0
E
T
0
B
CC
0
E
T
0
B
CC
0
E
T
4
BCC07WR
BCC07WR
BCC07WR
BCC07WR
BCC07WR
BCC07WR
B
CC
0
9
M
R