Balluff BIS M-370-000-A02, Manual, Page: 32 / 198

INSTALLATION
25
2
2.2 BIS M-37_ ANTENNA MOUNTING
2.2.1 Direct Antenna Mounting
Only -371, -372, and -373 Antenna models
Figure 11 - Direct Antenna Mounting
The BIS M-37_RFID antennas (except BIS M-370-000-A02) are designed to be connected
directly to the BIS M-62_ Processor units using the hardware included in the Processor unit
package.
1. Connect the BIS M-37_ antenna to the BIS M-62_ processor unit by inserting the
RCA antenna plug into the RF port (RCA jack) on the processor unit, as shown
above.
2. Secure the antenna to the processor unit using the two 20 mm M5 screws and
washers provided with each BIS M-62_ processor unit. You can use the 4 mm hex
key wrench supplied with each Processor unit to tighten the screws to 1.7 Nm or 15
lbs per inch ± 10%.
3. Fasten the combined processor unit and antenna to your mounting fixture using M5
(or #10) diameter screws (not included).
Pass the screws through the antenna’s
mounting holes and the processor unit bracket, and secure them with appropriate
washers and nuts. Tighten screws to 1.7 Nm or 15 lbs per inch ± 10%.
To complete the installation, refer to the specific procedure for your Processor unit under par.
2.6.
Antenna Mounting Screws (M5 x 20 mm ) and
Washers (M5) included in BIS M-62_ package.