Balluff BAE SA-OH-059-YI-DP02, User Manual

Page: 56 / 62

24 english
8
Menu structure (continued)
8.6.2 Type
The output can be configured with Type.
Value Meaning Description
PNP PNP PNP output
NPN NPN NPN output
Push-Pull Push-Pull Push-Pull output
Tab. 8-11: Configuration – Type
8.6.3 Logic
With Logic, the input/output can be configured as inverted
or normal.
Value Meaning Description
Normal Normal Non-inverted logic
Inverted Inverted Inverted logic
Tab. 8-12: Configuration – Logic
8.6.4 Signal Source
With Signal Source, the internal signal source for the pin
can be selected. Various signal sources are available that
can be output or read on a pin.
Value Meaning
Digital Output
Pin 4
Delay Ch 1
Signal Delay Channel 1
Pin 2
Delay Ch 2
Signal Delay Channel 2
Alarm Signal Quality Bad *
Digital Input
Pin 2
Teach-In
Teach-in
Transd.En. Transducer Enable
CounterRst Switching Counter Reset
Pin 5 (only in Dxxx)
Teach-In
Teach-in
Transd.En. Transducer Enable
CounterRst Switching Counter Reset
Tab. 8-13: Configuration – Signal Source
* if pin 5 is used as teach-in at the same time, the teach
confirmation pulses are output with a length of 100 ms via
pin2 parallel to the alarm pulses.
8.6.5 SSC Mode
Value Meaning Description
Single Pt Single Point Single-Point Mode
(SP1 activated)
Window Window Window Mode
(SP1 + SP2 activated)
Two Pt Two Point Two-Point Mode
(SP1 + SP2 activated)
Dyn. neg Dynamic, falling
edge
Single point mode, with
dynamic signal evaluation,
falling edge
Dyn. pos Dynamic, rising
edge
Single point mode, with
dynamic signal evaluation,
rising edge
Th.Trk
neg
Threshold
tracking, falling
edge
Single point mode, with
switching threshold tracking,
falling edge
Th.Trk
pos
Threshold
tracking, rising
edge
Single point mode, with
switching threshold tracking,
rising edge
Tab. 8-14: Configuration – SSC Mode
8.6.6 Power Mode
The power mode “High” should only be used if the high
power is really needed in order to avoid unnecessary high
current consumption and heating of the BAE. The modes
“Low” and “Extra Low” are mainly intended for transmitted
light barriers with short distance between transmitter and
receiver.
The LED pulse peak current depends on the speed mode:
Value
Descrip-
tion
Standard,
Sync6,
Sync8,
Precision,
High Precision 25 Hz
High Precision 30 Hz
Fast
Super-
fast
High High 180mA 90mA 60mA
Std Standard 100mA 50mA 33mA
Low Low 55mA 27mA 18mA
Xlow Extra Low 18mA 18mA 18mA
Tab. 8-15: Configuration – Power Mode
BAE SA-OH-059-YI-----
Photoelectric Sensors