Care2
Installation Instructions
Care2 issue 7
49
4.6 M
ANUALLY
S
PECIFY
O
UTSTATION
T
YPE
Follow steps (1) to (6) of the Auto Assign Procedure (page 45) to
open the “Line Parameters” menu.
1. Select the line required (in this example Outstation 1) and
the parameters for that line will be displayed.
Figure 4.18 — Line Parameters for Outstation 1
2. Press the Encoder to change the icon of the Outstation to
match the Remote Unit in use.
The available Icons are:
Console Handset
Stewards Telephone
Fire Telephone
Disabled Refuge Remote
Disabled Toilet Alarm x1 (Single Pullcord)
Disabled Toilet Alarm x 2 (Dual Pullcords)
Roaming Telephone Jack Socket
Roaming Telephone Enclosure
Disable Refuge with Firephone (Future Use)
3. Scroll up or down to highlight the Icon suitable for the
Remote Unit in use.
4. Press the Encoder to store the correct Icon.
N
OTE
: The Outstation Type is normally specified during the SD or IP
Configuration. This procedure shows how to manually specify the
outstation type using the front panel controls.
