Balboa BP6013G1, Installation And Directions Of Use

Page: 8 / 39

- 7 -
Filtration and Ozone
On non-circ systems, Pump 1 low and the ozone generator will run during filtration. On circ systems, the ozone
will generally run with the circ pump, but can be limited to filtration cycles.
The system is factory-programmed with one filter cycle that will run in the evening (assuming the time-of-day is
properly set) when energy rates are often lower. The filter time and duration are programmable. A second filter
cycle can be enabled as needed.
At the start of each filter cycle, the water devices like blower, mist device (if these exist) and other pumps will run
briefly to purge the plumbing to maintain good water quality.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature, then the water devices
automatically activate to provide freeze protection. The water devices will run either continuously or periodically
depending on conditions.
In colder climates, an optional additional freeze sensor may be added to protect against freeze conditions that
may not be sensed by the standard sensors. Auxiliary freeze sensor protection acts similarly except with the
temperature thresholds determined by the switch. See your dealer for details.
Clean-up Cycle(Optional)
When a pump or blower is turned on by a button press, a clean-up cycle begins 30 minutes after the pump or
blower is turned off or times out. The pump and the ozone generator will run for 30 minutes or more, depending
on the system.
(3)Temperature and Temp Range
Adjusting the Set Temperature
When using a panel with Up and Down buttons (Temperature buttons), pressing Up or Down will cause the
temperature to flash. Pressing a temperature button again will adjust the set temperature in the direction
indicated on the button. When the LCD stops flashing, the spa will heat to the new set temperature when
required.
If the panel has a single temperature button, pressing the button will cause the temperature to fl ash. Pressing
the button again will cause the temperature to change in one direction . After allowing the display to stop flashing,
pressing the Temperature Button will cause the temperature to fl ash and the next press will change the
temperature in the opposite direction
The temperature can be set between 60
°
F and 104
°
F.
Press-and-Hold
If a Temperature button is pressed and held when the temperature is flashing, the temperature will continue to
change until the button is released. If only one temperature button is available and the limit of the Temperature
Range is reached when the button is being held, the progression will reverse direction.
Dual Temperature Range
This system incorporates two temperature range settings with independent set temperatures. The High Range
designated in the display by an”up” arrow, and the Low Range designated in the display by a “down” arrow.
These ranges can be used for various reasons, with a common use being a “ready to use” setting vs. a
“vacation” setting.
The Ranges are chosen using the menu structure below. Each range maintains its own set temperature as
programmed by the user. This way, when a range is chosen, the spa will heat to the set temperature associated
with that range. High Range can be set between 80º F and 104º F. Low Range can be set between 50º F and
99º F. More specific Temp Ranges may be determined by the Manufacturer.
Freeze Protection is active in either range. See Ready and Rest,for additional heating control information.