42332_rev B
Heater Installation Guide
3
3S Heater Installation
©2019 Balboa Water Group. Single Source Solution. All rights reserved.
3030 Airway Avenue, Suite B | Costa Mesa, CA 92626 | p 714.384.0384 | www.balboawater.com
Specifications subject to change without notice.
Step 1
Power Off the system pack at the GFCI
or circuit breaker.
Step 2
Remove the system pack cover by loosening two
screws (F) with a phillips head screwdriver.
Step 3
If the agency prefix is BP501 or BP6, disconnect the
heater connector (B) from J46 on the circuit board.
If the agency prefix is BP20 or BP21, disconnect the
heater connector (B) from J44 on the circuit board.
.
Installation Instructions
System pack with cover
F
Tools / Supplies
3S Heater
Wrench, 3/8” (9.5mm),
open end
Phillips screwdriver
Nyogel 760G
Applicator stick
for Nyogel
Heater
Connector
B
3S Heater
