BALAY 3HB558.PE, Instruction Manual

Page: 11 / 20

11
Light
The oven light can be turned on manually to facilitate cleaning.
Connecting the oven bulb
Turn the function control knob to the
N
position.
The light will come on.
Turning the oven light off
Turn the function control knob to the
Û
position.
Removing and refitting the wire shelves or left
and right hand side rails
The wire shelves or left and right hand side rails can be
removed for cleaning. The oven must be cold.
Removing the wire shelves or rails
1.
Lift the wire shelf or rail from the front
2.
and release it (figure A).
3.
Then pull the wire shelf or rail completely out and remove it
(figure B).
Clean the wire shelves or rails with washing-up liquid and a
sponge. The use of a brush is recommended for stubborn
stains.
Install the wire shelves or rails
1.
First insert the shelf or the rail in the rear groove by pushing it
back slightly (figure A)
2.
then insert it in the front groove (figure B).
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.
Unhooking and hanging the oven door
The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
ã=
Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Unhooking the door
1.
Fully open the oven door.
2.
Remove both locking levers located on the right and left hand
sides (figure A).
3.
Fully close the oven door as far as possible (figure B). Grip
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
Oven interior Hot water with a little soap or water
and vinegar:
Clean with a dishcloth.
If very dirty, use a stainless steel
scourer or special oven cleaning
products. These must only be used
on a cold oven.
Whenever possible, use the self-
cleaning function. See the chapter
on the Self-cleaning function.
Glass cover for the oven
light
Hot water and a little soap:
Clean with a dishcloth.
Seal (do not remove) Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Wire shelves or rails Hot water and a little soap:
Soak them clean using a dishcloth
or brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush.
Do not leave this to soak or wash in
a dishwasher.
Accessories Hot water and a little soap:
Soak them clean using a dishcloth
or brush.
Zone Cleaning products
% $
% $
% $
% $