ADDING LOWER MOUNT PULLEYS
16. Hold the drill template on the outside of the frame, in either
position as shown in Figure H
.
17. If you have a tower, the top curves of the drill template will
fit and match the tower bracket. If you do not have a tower
bracket, the inside “L” of the template will be aligned with the
inside corners of the frame.
18. Once the template is in position, tape it in place to secure it.
You can also hold the template in position and mark the hole
on the wood with a pencil, then remove the template to drill
the marked location.
19. Using the provided drill bit, drill through the wooden frame.
Remove the drill template and tape, flip it over and place on
the opposite side to drill the other hole. Tape in place and drill.
20.Remove any burrs or wood splinters from both sides of the
frame.
21.Install the Pulley Spring Assembly as shown in Figure J. There
will be one plastic spacer on both sides of the pulley spring,
one will be against the side of the wood, and on the outside
frame, a washer, nut then acorn nut.
INSTALL RISERS
22.Remove the metal risers from your existing reformer by
removing the detent pins that go through the risers.
23.Install the new riser assemblies into the riser receivers and
install the detent pins. See Figure K.
INSTALL ROPE AND LOOPS
24. Place the black loops with pulleys on the shoulder posts. See
Figure L.
25. Thread one end of the rope through both pulleys under the
carriage and pull the ends evenly toward the risers.
See Figure M.
Figure L
Loop
Pulley
Figure M
Figure G
Figure H
Figure J
Figure K
3
