Baker Panametrics PanaFlow LC, User Manual, Page: 48 / 68

Chapter 4. Error Codes and Troubleshooting
40 PanaFlow™ LC User’s Manual
4.7 Communication Errors (C-Errors)
The communication error indicates that the Transmitter subsystem has lost communication with Flow measurement
sub-system or the Option I/O sub-system.
4.8 Transmitter Errors
These errors are from the Transmitter subsystem. Should you encounter one of the Transmitter Errors, follow
recommended actions as indicated in Table 6 and contact Panametrics factory.
S29: Output A Loop Open! SIL Analog Output Open Error Fault: SIL Analog Output is disconnected. Connect
the SIL Analog output and try power cycling the
meter. If error persists after power cycle, contact
Panametrics factory
S30: Flash Save Failed Save to Flash Failed Error: Request to Save failed. Try again. If error
persists, contact Panametrics factory.
Table 5: Communication Error Description and Recommended Actions
Error Code Error Message Description / Recommended Action
C1: Flow COMM Error Flow board communication
error
Transmitter cannot communicate to the flow
measurement unit. Try power cycling the meter. If
error persists after power cycle, contact
Panametrics factory
C2: MODE MISMATCH Mode Mismatch Error Fault: Mode Mismatch Error, Try power cycling the
meter. If error persists after power cycle, contact
Panametrics factory
C3: Option I/O COMM Error Optional I/O subsystem
communication error
Transmitter cannot communicate to the Optional
I/O in Slot-2. Try power cycling the meter. If error
persists after power cycle, contact Panametrics
factory
Table 6: Transmitter Error Description and Recommended Actions
Error Code Error Message Description / Recommended Action
X1: MCU RAM Error Transmitter RAM Fail Memory test on transmitter RAM failed. Try power
cycling the meter. If error persists after power cycle,
contact Panametrics factory
X2: MCU Flash CRC Error Flash memory test failed Flash memory test failed. Try power cycling the
meter. If error persists after power cycle, contact
Panametrics factory
X7: MPU not Detected No flow board detected Flow board is not detected by the transmitter. Try
power cycling the meter. If error persists after power
cycle, contact Panametrics factory
X12: System Command
Fail
System command failed System command failed. Try power cycling the
meter. If error persists after power cycle, contact
Panametrics factory
X13: Get GUI Node Fail Failed to generate GUI Failed to generate GUI. Try power cycling the meter.
If error persists after power cycle, contact
Panametrics factory
X14: Node Memory Fail GUI node memory failed GUI node memory failed. Try power cycling the
meter. If error persists after power cycle, contact
Panametrics factory
Table 4: System Error Description and Recommended Actions
Error Code Error Message Description / Recommended Action