Baker Panametrics PanaFlow LC, User Manual, Page: 37 / 68

PanaFlow™ LC User’s Manual 29
Chapter 3. Programming
3.3.1.3 Selecting a Channel Measurement to Display
To select a Channel measurement to display on the Measurement View , do the following steps and refer Figure 36 .
1. Press [

] until the Measurement name on the meter’s Measurement View display is highlighted, then press
[ENTER] .
2. In the Display Measurement select [Channel x] , then press [ENTER] .
3. Then, select the measurement you would like to see on the Measurement View and press [ENTER] .
Figure 36: Selecting a Channel Measurement to Display
0.000
m/s
Display Measurement
Channel 2
Channel 3
Composite
Ch1/Inv Vol Measure
Channel 1
Velocity
Volumetric (Act)
Volumetric (Std)
Channel 1
Raw Velocity
9
2
9
Velocity
m/s
m/s
0.000
0.000
Mass Flow
Avg Vol Flow Rate
Batch Vol Total
Inventory Vol Total
Channel 1
Batch Mass Total
Inventory MassTotal
Soundspeed
Gain
Channel 1
Gain
Std Deviation Gain
K-Factor
Diagnostics
Fwd Vol Inventory
Rev Vol Inventory
Net Vol Inventory
Inventory Time
9
2
9
or
2
9
or
(or)
Ch 1 Velocity
Ch 1 Velocity
Channel 1
Ch 1/Diagnostics
Transit Time Up
Transit Time Dn
Delta-T
Ch 1/Diagnostics
Sig Quality Dn
9
Sig Quality Up
Amplitude Up
Amplitude Dn
SNR Up
Ch 1/Diagnostics
SNR Dn
Gain Up
Gain Dn
Error Status
Ch 1/Diagnostics
ATw Amplitude Up
ATw Amplitude Dn
ATw SNR Up
ATw SNR Dn
2
9
or
Ch 1/Diagnostics
Wedge Soundspeed
Wall Time
Lining Time
Angle in Fluid
Ch 1/Diagnostics
ATw Gain Up
ATw Gain Dn
Wedge Soundspeed
Wall Time
๰
๰