Baker Panametrics PanaFlow LC, User Manual, Page: 36 / 68

Chapter 3. Programming
28 PanaFlow™ LC User’s Manual
3.3.1.2 Selecting a Composite Measurement to Display
To select a composite measurement to display on the Measurement View , do the following steps and refer Figure 35 .
1. Press [

] until the Measurement name on the meter’s Measurement View display is highlighted, and press
[ENTER] .
2. In the Display Measurement select [Composite] , then press [ENTER] .
3. Then, select the measurement you would like to see on the Measurement View and press [ENTER] .
Figure 35: Selecting a Composite Measurement to Display
0.000
m/s
Display Measurement
Channel 1
Channel 2
Channel 3
Composite
Inv Vol Measure
Composite
Velocity
Volumetric (Act)
Volumetric (Std)
Composite
Raw Velocity
9
2
9
Velocity
m/s
m/s
0.000
Velocity
0.000
Mass
Avg Vol Flow Rate
Batch Vol Total
Inventory Vol Total
Composite
Batch Mass Total
Inventory MassTotal
Soundspeed
Std Dev of SoS
Composite
K-Factor
Reynolds K-Factor
Reynolds #
On Board Temperature
Composite
Reynolds #
On Board Temperature
Diagnostics
Inputs
Composite
Reynolds #
On Board Temperature
Inputs
Diagnostics
Fwd Vol Inventory
Rev Vol Inventory
Net Vol Inventory
Inventory Time
9
2
9
or
Fluid Temperature
Pressure
9
Diagnostic
Cycle Time
9
2
9
or
Inputs
2
9
or
(or)
Velocity
2
9
or
๰
๰