Baker Panametrics PanaFlow LC, User Manual, Page: 30 / 68

Chapter 2. Installation
22 PanaFlow™ LC User’s Manual
2.6 Wiring instructions
Please refer to the XMT1000 User Manual for wiring of:
•
Analog outputs
• Digital outputs (totalizer, frequency, calibration)
• Modbus or Service port
• Hart or Foundation Field Ports (if applicable)
• Additional analog input or output (if applicable)
• Additional SIL analog output (If applicable)
• Transducer (flying leads)
• Line power
2.6.1 Three Channel Setup
The XMT1000 User manual details wiring for a one or two channel installation. However, for a three channel system,
please follow the instructions below.
Components of a three channel PanaFlow LC will be: a meter head, 6 conductor “trunk” cable, 3 channel junction box,
6 transducer cables and 3 sets of transducers and clamping fixtures. Mount meter head and junction box to a two
inch post using included hardware or another location following local electrical and building codes.
Install transducers as mentioned in
Section 2.4.3.3 "Installation of Transducer” . Prepare to wire transducer cables.
Note: US/ Canada installations will be required to provide conduit per their particular location. European
installations will include armored cable.
2.6.1.1 Transducer Wiring (ATEX installations)
1. Thread MCX end of 6 conductor cable trunk into XMT1000 meter head and the BNC connector end of the cable
into the 3 channel Junction box as seen in Figure 29 .
Figure 29: XMT1000 Trunk cable Placement