Model CTF878 Programming Manual
1
Chapter 1. Programming Site Data
Chapter 1. Programming Site Data
1.1
Introduction
This chapter provides instructions for entering the programming data required to place the CTF878 flowmeter into
operation. Before the CTF878 can begin taking measurements and displaying valid data, the current system and
pipe parameters must be entered. Additional programming options provide access to the more advanced features
of the CTF878, but this information is not required to begin taking measurements.
1.2
Powering UP
Immediately upon power up the CTF878 emits a short beep and displays a “PCI Loader” message. It then validates
the instrument programming, and displays the Panametrics logo and the software version. If the meter fails any of
these tests, contact the factory.
After the meter conducts all the self checks, the screen then appears similar to the one shown in Figure 1 below.
Figure 1: Screen After Powering ON
1.3
Using the Screen
The essential features for operating the CTF878 are the screen and keypad. Although these features are common,
the CTF878 design offers particular features to simplify and speed operation. The new menu system is very
user-friendly; program information is now located on tabbed forms instead of on a long, linear menu.
The primary function of the screen is to display information in order for you to take measurements accurately and
easily. The CTF878 screen consists of those parts shown in Figure 2 below.
0
50
100
DEFAULT 2003/07/17 03:35 PM