Chapter 2. Displaying and Configuring Data
38
Model CTF878 Programming Manual
4.
Use the [
] and [
] arrow keys to reach the desired category of data, and press
[SEL]
.
5.
Then use the [
] or [
] arrow keys to select the desired measurement unit (or diagnostic parameter). Press
[F3]
(OK) to confirm the entry or press
[
F2
]
(Cancel) to cancel the changes.
6.
The screen returns to Operate Mode, and displays any changes.
Figure 41: Measurement Menu Window
2.6 Customizing the Display Screen
You might wish to display one or two parameters, or customize the soft keys to quickly access particular menus. The
Site Menu enables you to make more comprehensive changes in your display screen.
To enter the Site Menu, press the
[MENU]
key at the lower right of the CTF878 keypad. The Menu Bar replaces the
Status Bar at the top of the screen. Scroll to the Site Menu using the [
] or [
] key. Press
[ENTER]
or the [
] arrow
key. The screen now appears similar to Figure 42 below. While following the programming instructions, refer to
.
Figure 42: Site Menu
•
To specify the number of parameters displayed, go to page 39.
•
To customize or clear softkeys (FKeys), go to page 40.
Delta-T
OK
Cancel
No Unit
Rev Totalizer
Velocity
UserFunction
AuxIn
Pressure
Temperature
Volume
Fwd Totalizer
Corr SNR
Carr A Up
Carr A Dn
I A Up
Q A Up
I A Dn
Q A Dn
Carr G Up
TAU
Select Measurement
DIAG
Program Meter Logging Service
Save Now
1 View
2 View
3 View
4 View
FKeys
About
100
Site Manager
Diagnostics
Save Now
Site
Site Manager
Velocity, m/s
Cross Corr