Baker Hughes Panametrics Sentinel LCT8, User Manual, Page: 65 / 138

Figure 61: Setting Up a frequency/totalizer output
3.6.2 Setting up a frequency/totalizer output
To configure a frequency/totalizer output, refer to Figure 61 below and complete the steps on the next page.
NOTE: If necessary, refer to Table 4 on page 23 as a reminder about color code meanings.
Legend
Green At least user 3 level access required to follow the step.
Dotted
green
Not all transitional screens are shown (at least user 3 level
access required).
Green Option only visible to user 3 or above.
If you select linked, both outputs will be
set up the same, just 90° out of phase.
If you select independent, you will set up
each output separately.
55