Baker Hughes Panametrics Sentinel LCT8, User Manual

Page: 60 / 138

3.5.3 Setting reset totals
IMPORTANT
If the totalizer lock is enabled, the previous totals will not
be cleared by this process.
To reset the totals, refer to Figure 57 below and proceed as
follows:
NOTE: If necessary, refer to Table 4 on page 23 as a
reminder about color code meanings.
1. Refer to Primary pages on page 26 and navigate to
Page 4: configuration (generic).
2. Use the [

] and [

] keys to highlight reset totals and
press the [

] key twice to confirm your choice.
3. At the next screen, use the [

] and [

] keys to highlight
either the reset both or reset fwd totals or reset rev totals
option. Then, press the [

] key to confirm your selection
or press the [

] key to cancel and return to the previous
screen.
Figure 57: Resetting the fwd and/or rev totals
Legend
Green At least user 3 level access required to follow the step.
Dotted
green
Not all transitional screens are shown (at least user 3 level
access required).
Red Option only visible to user 1 or above.
Green Option only visible to user 3 or above.
50