Baker Hughes Panametrics PanaFlow Z3, User Manual

Page: 78 / 118

Chapter 5. Maintenance and Service
66 PanaFlow Z3 User’s Manual
Figure 46: Upstream “A” Plane Sensor Quadrant – View 3 (Bottom)
5.1.2.3 Instructions to Rotate the XMT1000 Transmitter
1. Before performing any rotation of the XMT1000 Transmitter, ensure that the enclosure is de-energized. Locate the
back of the XMT1000 Transmitter and remove the rear enclosure cover by turning it counter-clockwise.
2. Locate the connection ports within the transmitter enclosure and carefully unplug all six cables. It may be useful
to make a note of the cable configuration, as it must be restored at the end of this procedure. Allow the cables to
freely sit within the enclosure and ensure that no cables are caught or tangled after this is complete.
3. Locate the four screws that affix the transmitter to the adapter and remove them using an appropriate hex drive
tool. Once these are completely removed, they can be stored in a safe location.
4. The entire XMT1000 Transmitter should now be free to rotate about the axis of rotation shown in Figure 47. Rotate
the transmitter enclosure to your desired position, ensuring that screw hole alignment is maintained.
5. Align and affix the XMT1000 Transmitter by reinserting the four screws to each screw hole. Tighten these screws
using a hex drive tool.
6. Reconnect all six transducer cables to the XMT1000 electronics. Make sure that all cables are connected to the
appropriate port.
7. Reinstall the back cover to the transmitter enclosure by turning it in a clockwise direction. Continue rotating the
back cover until the end of the threads is reached. During this process, make sure that the transducer cables are
not damaged and are not pinched when the back cover is reinstalled.
WARNING!
All equipment should be de-energized prior to servicing.