Baker Hughes Panametrics Aurora H2O, User Manual

Page: 39 / 92

3.5 Setting up the outputs
3.5.1 Selecting an output for setup
To set up outputs, from
the main menu choose
outputs... and press enter.
The following screen
appears.
From the output menu
choose select and press
enter. The following screen
appears.
Use the arrow keys to
select the output (A, B
or C) to be set up, and
press enter.
3.5.2 Selecting output units
From the output menu,
select units and press
enter. Use the arrow keys
to select the unit type
and press enter. A screen
similar to the following
appears:
Use the arrow keys to
select a new unit. Press
enter to save (or cancel to
keep the previous value),
and return to the output
menu.
3.5.3 Selecting an output type
To change the output type,
from the output menu
select type and press
enter. A screen similar to
the following appears:
Use the arrow keys to
select a new output
type. Press enter to save
(or cancel to keep the
previous value), and return
to the output menu.
NOTE: If the ALM option is selected in the above menu, the
analog output will function as an alarm indicator. In this
mode, the analog output will remain at 0 mA during normal
operating conditions, but the analog output will be driven to
24 mA whenever there is an alarm condition.
3.5.4 Changing the upper output span
To adjust the upper output
span, from the output
menu select upper and
press enter. A screen
similar to the following
appears.
Use the left and right
arrow keys to select each
digit to be changed
and the up and down
arrow keys to increase or
decrease its value. Press
enter to save (or cancel to
keep the previous value),
and return to output
menu.
29