Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 65 / 174

AquaTrans™ AT600 User’s manual 55
Chapter 4. Initial setup and programming
4.6.4.2 HART
Note:
Verify that the HART function is installed and activated on your meter.
Setting the HART address
To set up HART communication, select digital
comm on the input/output screen and press
[√]. The following screen opens.
Press [√] again, and a screen similar to the
following opens.
To set the HART address, select address and
press [√]. A screen similar to the following
opens.
Press [√] again, and a screen similar to the
following opens.
The default setting is 0. Use the [

] or [

] key
to select a specific digit, then use the [

] or
[

] key to change that digit as required.
After all digits are correct, press [√] to save.
Then, press [x] to return to the previous
screen.