Baker Hughes Panametrics AquaTrans AT600, User Manual

Page: 40 / 174

Chapter 4. Initial setup and programming
30 AquaTrans™ AT600 User’s manual
4.3.1 Changing the display for one- or two variable screens
An outline of a typical one- or two-variable screen is shown below.
To change the number of decimal places in the displayed value:
From the display screen,
press either the [

] or [

]
keys until the value is
highlighted.
After the value is
highlighted, press [√] to
open the display/decimal
option.
Use the [

] and [

] keys to
scroll to the desired value.
(Available options include
0, 1, 2, 3, 4, and Sci (Scientific
Notation). Press [√] to
select the value, and then
press [√] again to confirm
the selection or [x] to
cancel the selection.
Measurement type
Value units
Value
Error code