Baker Hughes PanaFlow Z1G, User Manual

Page: 7 / 59

Product registration
Thank you for purchasing your PanaFlow™ Z1G/Z2G Process
Gas FlowMeter from Baker Hughes, a Panametrics Company.
Please register your product at https://info.bakerhughes.
com/New-Product-Registration-LP.html for product support
such as the latest software/firmware upgrades, product
information and special promotions.
Services
Panametrics provides customers with an experienced
staff of customer support personnel ready to respond
to technical inquiries, as well as other remote and on-
site support needs. To complement our broad portfolio
of industry-leading solutions, we offer several types of
flexible and scalable support services including: Training,
Product Repairs, Extended Warranties, Service Agreements
and more. Please visit https://www.bakerhughesds.com/
panametrics/services for more details.
Terms and conditions
Sales Terms and Conditions for your recent purchase of
a Panametrics product, including the applicable product
Warranty, can be found on our website at the following link:
https://www.bakerhughesds.com/sales-terms-conditions
Typographical conventions
Note: These paragraphs provide information that provides a
deeper understanding of the situation, but is not essential to
the proper completion of the instructions.
IMPORTANT:
These paragraphs provide information that emphasizes
instructions that are essential to proper setup of the
equipment. Failure to follow these instructions carefully
may cause unreliable performance.
CAUTION!
This symbol indicates a risk of potential minor
personal injury and/or severe damage to
the equipment, unless these instructions are
followed carefully.
WARNING!
This symbol indicates a risk of potential
serious personal injury, unless these
instructions are followed carefully.
Safety issues
WARNING!
It is the responsibility of the user to make sure
all local, county, state and national codes,
regulations, rules and laws related to safety
and safe operating conditions are met for
each installation.
Attention European customers!
To meet CE Mark requirements for all units
intended for use in the EU, all electrical
cables must be installed as described in this
manual.
vii