Baker Hughes Druck DPI 610E-HC, Quick Start Manual

Page: 9 / 232

Copyright 2022 Baker Hughes Company.
English–DPI 610E Quick Start & Safety Manual | 3
1.4 Over-voltage categories
1.5 Repair
For details, please see:
bakerhughesds.com/druck/global-service-support
1.6 Maintenance and Inspection
The product should be periodically inspected for signs of
damage (e.g. case cracking, pressure connector damage)
or pressure leakage prior to use to ensure continued safe
working.
For details, please see:
bakerhughesds.com/druck/global-service-support
Clean the surface of the instrument should using a damp
cloth with water and mild detergent. Do not submerge the
instrument in water.
To calibrate the instrument, or for further details please
contact: bakerhughesds.com/druck/global-service-
support
1.7 Disposal
For more information contact one of:
•
Our Customer Service Department:
Druck.com/expert
• Your local government office
1.8 Environmental Conditions
1.9 Media Compatibility
Note: Sensors rated up to 3.5 bar (including differential)
are exposed. Sensors rated between 7 and 1400 bar are
diaphragm isolated.
Note: Only fluids that are compatible as per above table
should be used. This is to ensure the integrity of the
pressure sensor and avoid fluid leakage.
Over-voltage
Category
Description
CAT I
This is the least severe over-voltage transient.
CAT I equipment cannot be directly connected
to the mains power. An example of CAT I
equipment is a process loop powered device.
CAT II
This is for single phase electrical installation.
Examples are appliances and portable tools.
WARNING
Servicing or repairing the
equipment may result in damage to property
and serious personal injury (including death).
It is important that service and repair are only
carried out by a Druck authorized service
provider.
Repair activities undertaken by unauthorized
personnel may invalidate the equipment
warranty. Druck cannot be held liable for any
damage (including damage to the equipment),
monetary fine or personal injury (including
death) that may occur during or as a result of
service maintenance or repair work
undertaken by an unauthorized service
provider.
Internal component may be under pressure or
present other hazards if abused.
INFORMATION
Pressure leakage may be
cause failure to maintain pressure after
pumping or by visible fluid leakage (hydraulic
units) or audible air leakage (pneumatic units).
Do not dispose of this
product as household
waste.
Use an approved
organization that collects
and/or recycles waste
electrical can electronic
equipment.
Condition DPI 610E Mains Plugtop
149M4334 1
Outdoor Use
Not for permanent
installation outdoors For indoor use only
IP Rating IP54 IP20
Operating
Temperature
-10 to 50°C 0 to 45°C
Storage and
Shipping
Temperature
-20 to 70°C -20 to 70°C
Altitude -300 to 2000m -300 to 2000m
Operating humidity
0 to 95% relative
humidity (RH) non-
condensing
0 to 95% relative
humidity (RH) non-
condensing
Over-voltage
category
2 2
Pollution degree 1 1
Pressure FS
Media Compatibility
0 to 3.5 bar
Fluids compatible with stainless
steel 316L, pyrex, silicon, gold,
aluminum and structural
adhesive
Differential sensor reference
port
Fluids compatible with Stainless
Steel 316L and 304, Pyrex,
Silicon and Structural Adhesive
7 to 1000 bar
Fluids compatible with stainless
steel 316L and Hastelloy C276