10 ft/lbs
6
5
9
Set the cover in the folded position on the rails
towards the front of cab.
7
Place the 2nd
clamp near the
center of the
rail. See steps 4
and 5 to ensure
the clamp goes
on correctly.
(8’ beds-evenly
space 2 clamps
between ends).
10
Part# 318A0029 Rev. 1.8.2020
© Laurmark Enterprise, Inc. 2020
Apply downward pressure to the
rail when tightening the clamp to
ensure the rail sets flush and
seals properly.
A second set of hands
may help.
Place the rear clamp approximately 6 inches (152 mm) from the
tailgate. Tighten all of the clamps until snug. Then torque an
additional 1/2 turn, (10 ft-lbs).
Repeat steps 2-7 on the opposite side.
8
IMPORTANT
Before placing the cover on the truck, use a screwdriver
to install the two buckle ends into the pre-drilled holes on
the front header panel with the provided machine screws
and threaded posts
DO NOT
use a screw gun, securely tighten by hand only.
The small panel faces forward, toward the cab and folds down
over the slotted rail brackets. The front panel must sit just inside
the bulkhead rail with the seal resting on top of the bulkhead.
Fold the panel down and align it so it is setting squarely on the
rails and align the mounting holes with the slotted rail brackets.
• 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
BAK Industries
11
Insert the large
flat bolt through
the front panel
and the slotted
bracket on each
side.