30
Service Support - M/C
Service Station Manual
Condition 2 : Ignition ON, Kill switch ON,
Engine ON
Headlight Switch
Position
Headlight
Effect on pressing
Pass switch
Low beam
Low beam
ON
High beam
High beam
High beam
ON
High beam,
No change
Headlight
Side Stand
Side stand condition
Side stand Indication in speedometer
Gear position
Remark
Down
Yes
Neutral
Vehicle gets started after
pressing self start button
Yes
Gear is applied in vehicle
start condition by pressing
clutch lever
Vehicle gets OFF
Down
Yes
Gear
Self starter is disabled,
vehicle will not start
Steering cum Ignition switch
LED Headlamp Condensation:
Condensation inside headlamp is a natural phenomenon. Condensation occurs when atmospheric air containing
water vapor or humidity enters the headlamp through the vents due to temperature difference. A thin film of fog can
form on the inside surface of the headlamp lens. The thin fog will clear and exit through the vents during normal
operating condition. Condensation & fogging of headlamp lens may happen during rain or after washing. Moisture
condensation inside the headlamp lens will disappear gradually by switching ON the headlamp in high beam and
driving the vehicle at 30 to 40 Kmph speed for about 15 minutes. Time for evaporation will vary depending on the
humidity of the ambient air.
CONTROL SWITCHES / IGNITION SWITCH / HEADLIGHT /SIDE STAND INFORMATION
Position Lamp
Summary of Contents for pulsar F250 2022
Page 1: ...Service Station Manual...
