38
How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive
(+) pole of the battery.
(See figure 5)
2. Connect the black negative (-) cable to the black
negative (-) pole of the battery.
(See figure 6)
Note: The red positive (+) cable has a larger diameter
than the black negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
· After charging is complete, press down firmly with
both hands to seat the caps. (Do not pound or
hammer.) The battery is now sealed.
(See figure 7)
· Install battery in the ATV and make sure it is
secured properly.
(See figure 8)
· Once battery is firmly seated in gray tray with rubber
mat under it, attach the red positive wire to the red
positive terminal on the battery.
(See figure 9)
· Then attach the black negative wire to the black
negative terminal on the battery.
(See figure 10)
WARNING
NEVER REMOVE THE STRIP OF CAPS NOR
ADD ANY WATER OR ELECTROLYTE.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 10
Figure 9