Step 1 - Corner Leg Assembly
Place the Table Top and Apron Assembly upside down on a smooth, clean surface.
Place one Corner Leg in each corner at the gap in the Apron, with the notch and starter
hole facing inside towards the Corner Brace.
Attach each of the four (4)Corner Legs using one (1) Lag Bolt, Lockwasher and
Flatwasher as shown in Figure 2. Tighten each Lag Bolt gradually and in sequence
between the four corners until the Lockwasher flattens out and the Corner Leg is drawn
securely into the Apron gap.
Note: tightening each corner fully before starting the next one may result in a warped
or distorted Table. If this occurs, loosen all Lag Bolts until Table flattens out, and
gradually retighten Lag Bolts in sequence.
CONTINUED ON NEXT PAGE
Model 452, 453, 456 & 457 Stationary 5 x 7 & 6 x 8
Mat Tables - Assembly Instructions
5x7 & 6x8 HARDWARE LIST:
CORNER LEGS
The following Hardware Kit is packaged
in a poly bag with the Table:
•
(4) EA. # 2401 Lag Bolt, 3/8 x 4”
•
(4) EA. # 3597 Lockwasher, 3/8
•
(4) EA. #3610 SAE Flatwasher, 3/8
BAILEY MANUFACTURING COMPANY • 800-321-8372 •
www.baileymfg.com
Mat Table Corner Leg Assembly
Corner Leg
Table Top and
Apron Assembly
#2401
Lag Bolt
Corner Brace
#3597
Lockwasher
#3610
Flatwasher
Notch with
starter hole
