INSTALLATION
OPERATOR INTERFACE DEVICES
I-E96-192-5A
3 - 29
6. Attach the touch screen controller card to the MKM card
with the four nylon spacers and screws.
CALIBRATING THE TOUCH SCREEN
On-line calibration can be done from the console. For operating
information, refer to the operation and configuration instruction.
TOUCH SCREEN JUMPER AND SWITCH SETTINGS
Jumpers J6 and J8 on the IIMKM02A keyboard module con-
trol the touch screen option (Figure
). Switch S1 and S2 on
the touch screen controller board must also be set.
1. Set jumpers J6 and J8 at 2 to 3 on the IIMKM02A board.
2. Jumpers J7 and J9 are for future use.
NOTE: Setting jumpers at 2 to 3 disconnects the IIMKM02A lead. A
cable then connects the touch screen controller directly to the CPU
port 1. When not using the touch screen option, jumpers J6 and J8
can be in any position.
3. Set switches S1 and S2 on the touch screen controller
board. See Figure
Figure 3-22. Touch Screen Controller Card Connections
COMPONENT
SIDE
P15
MKM BOARD
P14
TOUCH SCREEN
CARD 1
TP80549A
.
