25
25
Squaring Arm
The squaring arm is used to square the material to the shear
blade. It can also be used for front gauging by utilizing the
graduated scale or as a material support. The adjustable rotating
dog pivots out of the way when material passes over it. The dog
pops up when the material passes allowing it to be used as a stop
at a predetermined dimension.
To mount the squaring arm, remove the two bolts, (
AD
). Back off
both bolts (
AE
) a bit. Set the arm onto the 6mm pin and replace
bolts (
AD
). Note:
DO
NOT
tighten at this time. Using bolts (
AE
),
square the arm to the blade and then tighten bolts (
AD
).
Material Support Arm
The support arms are used to support material at the front of the
machine. Each arm has an adjustable rotating dog that pivots out
of the way when material passes over it and pops up after the
material has passed.
To mount a support arm, remove the two bolts (
AF
). Put the arm
in place, replace the bolts, and tighten them.
figure 17
figure 19
figure 18
AD
AE
AF
figure 20
Summary of Contents for SH-8008HD
