Baileigh RDB-480, Operator'S Manual, Page: 21 / 60

18
18
OPERATION
Programmer Overview
•
This draw bender utilizes a fully programmable touch screen operator interface. The unique
operator interface allows you to write and save 170 programs with 10 bends per program.
Operation is extremely simple to learn. Simple foot pedal controls allow you to easily
produce fast and accurate bends. The following instructions will walk you through the basic
functions.
•
Be sure to follow the dry running instructions to familiarize yourself with all the functions of
the control before any actual bending of material is performed.
Note: See the Screen Shots section of the manual to match the figure call outs.
Machine Start up and Homing
1. Tum the main power switch to the "ON" position.
2. It takes about 1 minute for the programmer to boot up. The machine has been homed from
the factory and does not need to be re-homed unless the encoder or drive motor needs
servicing.
In the Home or “0” position, the flat of the spindle drive keys are parallel to the
machine frame. (The hook arm of the die will also be parallel when a die is installed.)
3. The programmer will display the "RMD MAIN SCREEN" see Fig.1.
4. On the RMD MAIN SCREEN, you can chose "MANUAL MODE" or "RUN, VIEW OR EDIT A
PROGRAM".
Programmer Display and Key Functions
1. The touch screen control is very self-explanatory. By touching the labeled touch boxes on
the screen, the listed parameter or function will be selected. The exit box will return you to
the previous screen and get you back to the RMD MAIN SCREEN. When entering names
and degrees, a keypad will be displayed Fig 2 and 3.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
CAUTION:
Keep hands and fingers clear of the dies and swing arms.
Stand to the front of the machine to avoid getting hit with the material during the
bending process. When handling large heavy materials make sure they are properly
supported.