Baileigh BS-916M, Operator'S Manual

Page: 17 / 52

14
14
ASSEMBLY AND SET UP
For shipping purposes, the control box, the blade tension hand wheel, the bow lift handle, the
material stop assembly, and the motor and belt guard have be removed and will require
assembly to the machine.
Control Panel
1. Locate and remove the mounting bolts and
washers from the top of the saw bow.
2. Remove the packaging from the control box and
position the mounting tabs over the mounting holes
with the controls facing the front of the saw and
watching that the hoses and wiring are not twisted
or pinched.
3. Install and tighten the washers and bolts to secure
the control box to the top of the saw bow.
Handles
4. On the left end of the bow, loosen the two thumb
screws and open the idler wheel cover.
5. Install the lift handle into the bow frame and secure
in place.
6. Remove the tape from the end of the blade tension
shaft being careful not to lose the key.
7. Install the hand wheel onto the shaft and tighten
the setscrew.
8. Close the idler wheel cover and tighten the two
thumb screws.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.