Baileigh Industrial WL-1218VS, Operator'S Manual, Page: 29 / 52

26
26
OPERATION
•
Tighten all screws and levers securely when adjusting any part of the lathe. Also, be sure
any lathe accessories are fastened and tightened before turning on the lathe.
•
When using the included 3" (76 mm) faceplate, do not mount pieces larger than 6" (152 mm)
in diameter and up to 6" (152 mm) in length. For mounting larger pieces, be sure to use an
appropriately sized faceplate.
•
Keep hands off workpiece when it is spinning.
•
Use only accessories recommended for this product and follow all instructions included with
the accessories.
•
Be sure cord is not in the way of the spinning workpiece or spinning lathe parts.
•
Do not touch the tip of your turning tool directly after it has been used on the workpiece as it
may be hot.
•
Do not apply water or other coolants to lathe when it is spinning.
•
Do not turn materials other than wood on this lathe. This lathe was designed for wood
turning only.
•
Be sure any chuck keys or wrenches are out of the chuck before operating the lathe.
•
Be sure to only use accessories equipped with locking set screws for turning the lathe in
reverse. Also, do not switch lathe turning directions until the workpiece comes to a complete
stop.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
WARNING:
Always lock the tailstock quill locking handle and the
tailstock release lever while the lathe is in use. The workpiece may be thrown from
the lathe if either of these remains unlocked.
Never extend the ta
ilstock quill more than 2” (50.8mm) out of the tailstock housing.
The quill will not be supported enough.
Failure to follow these warnings may result in personal injury.