Baileigh Industrial TN-600, Operator'S Manual

Page: 20 / 36

18
18
4. Position the material so the notch will end up being centered on the belt.
5. The depth of the notch is limited by the stop screw; this can be adjusted as needed, always
check for interferences before actually notching.
Off-center notches can be
accomplished by raising the “V” jaw of
the vise to the desired offset.
6.
To raise the “V” Jaws, loosen the
(4) bolts, (2) on either side of each
jaw.
7. Turn the top jack screws (E) until
the desired offset is reached on
each of the jaw assembly
’s.
8. Retighten the lock bolts.
Notching
1. With the motor running and the material clamped tightly in the vise, grab the main feed lever
and slowly pull the material into the spinning grinding belt.
2. Continue to feed until the desired notch depth is
achieved. Don’t feed too fast, this will cause
the belt to wear prematurely and may push the belt off the mandrel. Thinner wall material
can be notched faster than thick wall.
3. After the desired notch depth is reached, activate the stop switch.
4. Make sure the spindle has stopped completely before removing and installing material.
E