35
35
TROUBLESHOOTING
FAULT
PROBABLE CAUSE
REMEDY
Slip Roll creates cones
instead of cylinders.
A noticeable crease forms
in the piece part.
Piece part is pitted.
Rolls are not parallel to each
other.
Excessive pressure applied to
one spot.
Material sheet is dirty or roll is
damaged.
Adjust the rear roll to be
parallel to the top roll.
Reduce the radius and make
the bend in several passes.
Clean material, polish nicks in
roller.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Summary of Contents for SR-5016E
