24
24
DRIVE CHAIN ADJUSTMENT
The drive chain on the Baileigh 5016 slip roll has been properly adjusted at the factory. Because
of the relatively slow rpm of the drive components, there should be minimal wear on the chain.
To tighten the chain:
1. Disconnect and lockout power to the machine.
2. Remove the chain guard.
3. Loosen the (4) bolts holding the motor assembly to the base.
4. Allow the weight of the motor and gearbox assembly to hold the chain tight.
5. Tighten motor bolts.
6. ALWAYS replace the drive guard before running the machine!!
CAUTION:
Before removing the guards make sure that the power to the
machine has been disconnected.
Summary of Contents for SR-5016E
