Baileigh Industrial SR-5016E, Operator'S Manual

Page: 20 / 40

18
18
OPERATION
•
DO NOT exceed rated capacity on this slip roll. It has been tested at the factory to roll 16 Ga.
x 50” wide mild steel.
•
The Baileigh SR-
5016E slip roller has three 3” diameter rolls. The two front rolls, one placed
vertically above the other are clamping rolls. The bottom roll is adjustable for material
thickness up to 16 gauge. By turning the two bolts (
D ) clockwise ( cw) , the roller rises, closing
the gap. Counterclockwise ( ccw ) rotation lowers the roller or increases the gap between the
rolls. The rear roll controls the diameter of the finished piece part and is adjusted with two
bolts (
L ). Both ends of the rear roll have scales and indicator marks. This will help maintain
an equal distance between rolls along the entire length.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy material make sure they are properly supported.
L
Top Roll
Rear Roll
D
Shown with gear
cover removed
Bottom Roll
Scale