43
43
PRESSURE BAR ADJUSTMENT
The pressure bar should be set even with the
lowest point of knife.
1. Disconnect machine from power source.
2. Place a hard wood gauge under a knife in
cutterhead. Raise table until wood gauge
contacts the knife in its lowest position.
3. Place wood block (A, Fig 17) under the left side
of pressure bar (B, Fig 17). The top of wood
gauge should just contact the pressure bar. If it
doesn
’t, loosen jam nut (C, Fig 18) and turn the
adjusting screw (D, Fig 18) to raise, or lower the
pressure bar until it contacts wood gauge.
4. Repeat for opposite side of the pressure bar.
Fig. 17
Summary of Contents for IP-2509-HD-3
