Baileigh Industrial IP-2509-HD-3, Operator'S Manual

Page: 45 / 80

42
42
5. If it doesn
’t, loosen jam nut (C, Fig 15) and turn the adjusting screw (D, Fig 15) to raise, or
lower the in-feed roller until it contact the wood gauge.
6. Repeat for opposite side of the in-feed roller.
CHIPBREAKER ADJUSTMENT
Chipbreaker should be set 0.02
” below the lowest point of knife. Make sure the knives are set
properly. See the
“Setting / Changing Knives” section prior to making any adjustments.
1. Disconnect machine from power source.
2. Place a hard wood gauge (A, Fig 14) under a
knife in the cutterhead.
3.
Place a 0.02” feeler gauge (B, Fig 14) on top of
wood block and raise table until the gauge
contacts the knife in its lowest position.
4. Remove feeler gauge and place wood gauge
(E, Fig 16) under the left side of chipbreaker
(F, Fig 16).
5. The top of the wood gauge should just contact
the chipbreaker.
6.
If it doesn’t, remove the socket head cap screw (G, Fig 15) and remove washer (H, Fig 15),
or replace with shim of proper thickness to raise, or lower the chipbreaker until it contacts the
wood gauge.
7. Repeat for opposite side of the chipbreaker.
Fig. 16