37
37
RAISING AND LOWERING TABLE
Turn the handwheel (A) clockwise to raise the
table. One revolution equals 1/
32” or 0.03”.
Note:
The handwheel is spring
loaded. Push in on the handwheel and rotate
until the pins engage the detents.
ADJUSTING THICKNESS SCALE
1. Run a board through the planer and
measure the thickness of the planed board
with a pair of calipers.
2. Adjust the pointer (B) by loosening the screw that holds it in place.
Note:
This measurement should be the same as digital readout.
TABLE ROLLER ADJUSTMENT
1. Loosen the handle ( C) and move the table rollers up, or down by raising, or lowering the
handle ( D).
2. When you reach the desired position tighten the handle.
The rollers are usually set higher when planning rough stock. When planning smooth stock the
table rollers should be set slightly above, or flush with the table.
Summary of Contents for IP-2509-HD-3
