31
31
LOAD DATUM VALUES
The real value refers to the distance between the machine table and the cutterhead. Thus, the
cutterhead defines the zero point of the machine. It is, however, difficult or impossible to move
the planer table to this point. Therefore, the zero point should be identified by either placing a
gauge between table and cutterhead knife insert, or by planing a test board then measuring the
board thickness with calipers.
Program this real value into the Controller as follows.
Preset the Real Value:
1. Press
.
2. Enter the value.
3. Press
.
Load the Real Value:
1. Press
.
Display
2. Press
to confirm or press
to cancel.
Example:
The current value is 10.00mm but the actual thickness is 10.50mm.
1. Press
.
Summary of Contents for IP-2509-HD-3
