23
23
When the forward key is pressed, the planer table moves down. This is also achieved using the
“Table Down” push button on the planer. When the keypad is used, the upper display will show
while the 7 or 8 key is held.
When the backward key is pressed, the planer table moves up. This is also achieved using the
“Table Up” push button on the planer. When the keypad is used, the upper display will show
while the 9 or F key is held.
In Manual Mode, the planer table moves as long as a key is pressed and held. When the key is
released, the table stops.
This mode can be used for manual positioning, or adjusting procedures.
SINGLE MODE
In single mode, the device performs automatic positioning of the table to the programmed target
position. The “Table Up” or “Table Down” button on the planer should be pushed and held; when
the table has fully adjusted to the target position, the table will automatically stop in position.
Release the push button.
Setting Target Value
1. Press
(Target window [upper] LED starts blinking)
2. Enter the target value using numerical keypad.
3. Press
to complete.
4. The
LED lamp starts blinking. The controller is ready to start the positioning.
Start/Stop/Cancel
1. Press the
key to start the positioning. The LED lamp now stops blinking and
remains on during the procedure.
2. Press the
key to cancel the positioning. The LED lamp is turned off.
= HAnd
HAnd =
Summary of Contents for IP-2509-HD-3
