21
21
OPERATING CONTROLLER
The operating controller is used
to control the table height. The
height may be controlled directly
from the key pad, or a setting
may be entered and then
controlled by pressing the table
up or table down button on the
control panel.
The top LED display shows the
Target value. This is the value
that has been programmed into
the controller.
The lower LED display shows
the Real value. This is the
position the table is currently at.
The key pad is used to enter,
store, change etc. the values
needed by the operator.
Summary of Contents for IP-2509-HD-3
