17
17
Improper connection of the equipment-grounding conductor can result in risk of electric
shock. The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric
cord or plug is necessary, do not connect the equipment-grounding conductor to a live
terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
Repair or replace damaged or worn cord immediately.
Connecting Power Supply
You may either install a plug or “hard-wire” the Planer directly to a control panel.
If you are connecting a plug, use a proper UL/CSA listed 3-pole, 3-wire grounding plug
suitable for 230 volt operation.
If the Planer is to be hard-wired to a panel, make sure a disconnect switch is readily
available for the operator.
During hard-wiring of the Planer, make sure the fuses have been removed or the breakers
have been tripped in the circuit to which the Planer will be connected. Place a warning
placard on the fuse holder or circuit breaker to prevent it being turned on while the machine
is being wired.
Always
follow proper lockout /tagout procedures.
1. Lock power out to the circuit that will provide
power to the machine.
2. Remove the electrical box cover.
3. Route the electrical cable into the electrical box.
a. Route the power cord so that it will NOT
become entangled in the machine in any way.
b. Route the cord to the power supply is a way
that does NOT create a trip hazard.
4. Connect the three power wires terminals
L1, L2, &
L3
. Connect the ground wire (typically green) to
the
E
terminal.
WARNING:
In all cases, make certain the receptacle in question is
properly grounded. If you are not sure, have a qualified electrician check the
receptacle
.
Summary of Contents for IP-2509-HD-3
